Waldorf Nave - Manual (Page 42)

The Controls
Nave User Manual 42
X-Feed 0.00…1.00
Controls the feedback send from the left channel to the
right one and vice versa.
Dry / Wet 0…100%
This parameter controls the volume ratio between the
original signal and the effect output. If set to 0%, the dry
signal is sent to the output only so that no effect can be
heard. Higher values will increase the effect signal. At
maximum setting of 100%, the pure effect signal will be
heard.
Reverb diverse Parameters
The Reverb effect is probably the most widely used effect
in music production. Nave’s reverb effect is an addition
to the sound to make it more 3 dimensional and expres-
sive.
Time 0.0...1.00
Determines the reverb time. Lower settings simulate a
normal room while higher settings simulate a big hall or
church.
Color -1.00...+1.00
Determines the spectral colorization of the reverb sound.
Negative values dampen the higher frequencies while
positive settings dampen the deeper frequencies.
Predelay 0.00…1.00
Determines the delay between the direct sound and the
reverb effect output. Lower settings connect the reverb
more to the original signal while higher settings separate
the effect signal to produce a more spatious sound.
Dry / Wet 0…100%
This parameter controls the volume ratio between the
original signal and the effect output. If set to 0%, the dry
signal is sent to the output only so that no effect can be
heard. Higher values will increase the effect signal. At
maximum setting of 100%, the pure effect signal will be
heard.