Waldorf Nave - Manual (Page 40)

The Controls
Nave User Manual 40
Depth 0.00…1.00
Sets the modulation depth of the Flanger effect.
Feed -1.00...+1.00
Controls the feedback amount of the Flanger signal.
Dry / Wet 0…100%
This parameter controls the volume ratio between the
original signal and the effect output. If set to 0%, the dry
signal is sent to the output only so that no effect can be
heard. Higher values will increase the effect signal. At
maximum setting of 100%, the pure effect signal will be
heard.
Chorus diverse Parameters
A Chorus effect is generated by using comb filters that
generate slightly detuned copies of the input signal and
mix it into the output signal. The result sounds like an
ensemble of several simultaneous sounds, like a choir as
opposed to a single voice; hence the name Chorus. The
detuning is generated by an internal LFO that can be
controlled in speed and depth.
Speed 0.10...20.0
Sets the LFO speed of the Chorus effect.
Depth 0.00…1.00
Sets the modulation depth of the Chorus effect.
Dry / Wet 0…100%
This parameter controls the volume ratio between the
original signal and the effect output. If set to 0%, the dry
signal is sent to the output only so that no effect can be
heard. Higher values will increase the effect signal. At
maximum setting of 100%, the pure effect signal will be
heard.