Waldorf Nave - Manual (Page 21)

The Controls
21 Nave User Manual
Überwave Active On/ Off
Activates the Überwave function. This module can gene-
rate up to 8 oscillator signals simultaneously (only with
selected triangle, pulse or sawtooth shapes)
Überwave Density 0...8
Determines the number of played oscillators, when
Überwave
is activated.
Überwave Spread 0.00...1.00
Detunes the oscillators, when Überwave is activated.
Semitone -24...+24
Sets the pitch of the oscillator in semitone
steps. The standard setting for this parameter is
0, but there are cases where different values
are interesting as well, e.g. with values of -12
or -24 you can use the oscillator as a sub
oscillator.
Pulsewidth 0.01%...50%
Sets the pulse width of the Pulse waveform
(when selected). The minimal value is
equivalent to a pulse ratio of <1%, the
maximum value is equivalent to 50%
(square wave).
Other values creates asy-
metric square waves which contain equal
harmonics with different levels.
The following picture
illustrates the effect of the pulsewidth parameter:
Pulsewidth Modulation diverse functions
Activate this parameter by tapping on the button. Then
select a modulation source by tapping on the Modulati-
Pulse Width 50%
(Square)
Pulse Width 33% Pulse Width 25% Pulse Width <1%
(Impulse)