Waldorf Nave - Manual (Page 31)

The Controls
31 Nave User Manual
Speed 0...20 / 0.125...1024
Determines the frequency of the corres-
ponding LFO. At low values, it might take
several minutes to perform a complete
cycle while higher values are nearly in the
audible range. When Clocked is activated,
you can adjust the Speed in musical valu-
es. The lowest possible value is 1024 beats. That means,
that a complete LFO cycle would need 1024 beats.
Delay 0.0...10.0 s
Controls the speed in seconds, with which
the LFO is faded in. With this parameter you
can create slowly rising modulations that
might create interest when routed to wave,
pitch or volume.
Phase 0...360 deg, free
Controls the initial phase of the correspon-
ding LFO when a new note is started. Free
(maximum setting) means that the LFO isn’t
restarted on a new note but runs freely while
other values set the LFO phase to the respec-
tive offset in degrees.
Sync / Clocked Sync / Clocked / Off
This switch controls the synchronisation of
the corresponding LFO:
• When set to Sync, the LFO phases of
all voices are synced so that they
sound as one LFO. This can be inte-
resting when the LFO is applied to
modulate Cutoff or Pan.
• If Clocked is activated, the LFO is controlled by
the internal tempo of Nave (adjustable with Ar-
peggiator Speed on the FX & Arp menu page) or
an incoming synchronisation signal by another
App, MIDI or WIST. If so, you can set up Speed
in musical values. The highest amount is 1024,
where one turn needs 1024 beats. If Clocked is
active, the LFO also behaves as in Sync mode.
• Off deactivates all LFO synchronisations.