Waldorf Nave - Manual (Page 39)

The Controls
39 Nave User Manual
Phase 0.00…1.00
Sets the phase offset of the modulation oszillator between
left and right audio channel. Higher values lead to a
wider stereo range.
Depth 0.00…1.00
Sets the modulation depth of the Phaser effect.
Feed -1.00...+1.00
Controls the feedback amount of the signal.
Dry / Wet 0…100%
This parameter controls the volume ratio between the
original signal and the effect output. If set to 0%, the dry
signal is sent to the output only so that no effect can be
heard. Higher values will increase the effect signal. At
maximum setting of 100%, the pure effect signal will be
heard.
w
For the typical Phaser effect sound, the Dry / Wet
parameter should be set to 50%.
Flanger diverse Parameters
The Flanger effect is very similar to the Chorus effect, but
features feedback circuitry to feed the generated signal
back into the comb filter. This generates a deeper
detuning and colorizes the signal. With extreme settings
you can hear a whistling sound which is very characteris-
tic of a Flanger effect.
Speed 0.01...10.00
Sets the LFO speed of the Flanger effect.
Phase 0.00…1.00
Sets the phase offset of the modulation oscillator between
left and right audio channel. Higher values lead to a
wider stereo range.