Vortech 2005-2009 Ford 4.6L 3V Mustang GT User Manual

Page 5

P/N: 8N020-120

23SEPT08v3.0(8N..120v3.0)MaxflowPwrClr

VORTECH MAxFLOW POWER COOLER

Installation Instructions

2005-2009 Ford 4.6 Mustang GT (3-Valve)

Before beginning this installation,

please read through this entire instruction booklet

The Vortech Maxflow Power Cooler system was designed as a street/strip oriented aftercooler, specifically for

use on 2005-2008 Ford 4.6 Mustang vehicles equipped with a Vortech supercharger producing up to approxi-

mately 580 horsepower. V-Power upgrade producing approximately 850 horsepower.
As with any power enhancing product, this system is intended for use on healthy, well-maintained engines.

Vortech Engineering is not responsible for engine damage. Installation on new vehicles will not harm or

adversely affect the break-in period so long as factory break-in procedures are followed.
For best performance and continued durability, please take a note of the following key points:

Use only premium grade fuel 91 octane or higher (R+M/2).

Always listen for any sign of detonation (pinging) and discontinue hard use (no boost) until problem

is resolved.

TOOL & SUPPLY REQUIREMENTS:

• Open End Wrenches (7/16”, 9/16”, 5/8”, 11/16”)
• 3/8” Ratchet
• 8mm, 13mm, 9/16”and 18mm Sockets
• 5/32”, 3/16”, 9/16” Allen Wrenches
• Flat #2 Screwdriver
• Phillips #2 Screwdriver
• Utility Knife
• Torque Wrench (in/lbs)
• Wire Cutters, Strippers and Crimpers
• Drill Motor
• 1/8”, #21 Drill Bits
• Tape Measure
• Ford Springlock 3/8” Fuel Fitting Disconnect Tool
• Pipe Tape (Teflon)
• Adjustable Wrench

Congratulations on selecting the best performing

and most efficient aftercooler today...

the Vortech Maxflow Power Cooler!