Vortech 2005-2009 Ford 4.6L 3V Mustang GT User Manual

Page 32

P/N: 8N020-120

23SEPT08v3.0(8N..120v3.0)MaxflowPwrClr

Fig. 3E-d

Fig. 3E-e

10mm

HEADED

BOLT

RESERVOIR

BRACKET

Fig. 3E-f

3/4" HOSE ATTACHED

TO FACTORY 1" HOSE

Fig. 3E-g

3E. ENGINE COOLANT RESERVOIR INSTALLATION (2007 - 2008 MODELS ONLY), CONT’D

Remove the 10mm headed bolt that secures the

back of the ECU and the power distribution box.

(See Fig. 3E-d.)

Install the coolant reservoir. Secure the front of

the reservoir with the factory fastener removed

previously. (See Fig. 3E-e.)

Attach the rear mounting bracket with the surge

tank mounting bracket to the strut tower using the

factory strut mounting hardware. (See Fig. 3E-f.)

Attach a length of 3/4" hose (approximately 22"

long) to the 3/4" bung on the front of the coolant

reservoir. Secure using one of the #10 hose

clamps provided. Route the open end of the hose

to the 1" hose previously connected to the factory

coolant reservoir. Connect and secure the two

hoses using the 3/4" x 1" hose union, the factory

1" spring clamp and the #10 hose clamp provided.

NOTE: Leave this bolt loose for final adjustment in a

later step.

SURGE

TANK

RESERVOIR

BRACKET

COOLANT

RESERVOIR