Vortech 2009-2010 5.7L Hemi Cars (Charger, Challenger, 300C) - Manual (Page 5)

P/N: 4CL020-015 v1.0, 12/02/2014
©2014 Vortech Engineering, Inc
All Rights Reserved, Intl. Copr. Secured
v
ATTENTION
BEFORE STARTING INSTALLATION,
PLEASE NOTE THE FOLLOWING:
Your vehicle’s ECM may need to be updated.
This can be determined by locating the supplied
Diablosport programmer and plugging it into the
vehicle’s OBD2 port.
Once the programmer is powered up and is at the
main menu screen, there will be four options to
choose from:
Tune Vehicle •
Scan Tool •
Settings •
Select “Tune Vehicle “and follow the screen for
instructions.
If you are prompted to update the vehicle’s calibra-
tion, disconnect the Diablosport programmer and
follow these steps:
Tools required: Diablosport U7778 Interface Kit.
In the event you are unable to purchase or
locate a U7778 Interface Kit, this process can be
accomplished by using the vehicle for the power
source (by plugging the programmer into the ve-
hicles OBD2 port) and by purchasing a USB to
serial cable (RS232) (Note: if your computer has
a serial cable outlet plug then just a serial cable
will be needed).
If you are unable to use the vehicle as the power
source, a power supply will be required.
The requirement for the power supply: Input
120 VAC 60Hz 30W output 12 VDC 1000
Ma, with a 5.5 x 2.5 mm tip, positive center.
With the programmer powered up and connected,
and the main menu screen being displayed:
Type the following into your web browser: •
vortechsuperchargers.com/dsinstaller
Save the installer to your desktop. It should •
place an installer icon on your desktop.
Double-click on the DS Downloader installer •
on the desktop to start the installation process.
Follow the prompts to install.
Once the installer has completed, locate the •
new icon that the installer has placed on your
desktop. (See Fig)
With the programmer powered up and con- •
nected to your computer, double-click on the
DSDownloader icon. You should see an option
to download calibration update.
Select the update and allow the program to •
connect to Diablosport’s website. This may
take a few minutes.
Once the programmer has updated, discon- •
nect it from the power source and the com-
puter.
Plug the programmer into the vehicles OBD2 •
port and follow the main menu screen (as
described in section 10).