Vortech 2009-2010 5.7L Hemi Cars (Charger, Challenger, 300C) User Manual

Page 32

P/N: 4CL020-015 v1.0, 12/02/2014

TO FUEL PUMP

TO WIRING HARNESS

Fig. 11-d

J. Locate the factory fuel pump wires under the rear

seat driver’s side. Remove the tape from the wires.

Separate the blue with orange or blue with red

depending on model year (See Fig. 11-d).

K. Cut the blue with red/orange trace wire leaving

approximately 4”out of the fuel pump. Attach the

12ga. orange wire provided in your kit to the 12ga.

orange wire from the FPB. Attach the other end to

the fuel pump. This wire will power the fuel pump.

(Refer to wiring diagram Fig. 11-h)

L. Attach the 14ga. red wire provided in your kit to

the 14ga red wire from the FPB. Attach the other

end to the blue with red/orange trace wire into the

OEM wire harness. (Refer to wiring diagram Fig.

11-h)

NOTE:

Crimp on connectors are provided

but it is recommended that all of the

wire connections be soldered and

insulated.

11. FUEL PUMP VOLTAGE BOOSTER INSTALLATION con’t

NOTE:

Refer to the fuel pump wiring dia-

gram that is provided for further ex-

planation if needed (Fig. 11-h).