SurgeX SX-AX20E - Manual (Page 23)

Axess Elite User Manual
Firmware Version v1.06.227
© SurgeX | Technical Support: 800-645-9721 | surgex.com
3
6.5 Device Commands
Command Description Admi Fact Def
get all
get outlets get status Returns the status of all AC outlets and the following system level measurements:
• Device Name
• Line Voltage
• Total Current Draw
• Total Power Draw
• Total Energy Used
• Reboot Time currently in use
• Delay Time currently in use
• Temperature
• On/Off status of each outlet
• Current draw of each outlet
• Power Draw of each outlet
No
get outlet <1 ‐10>
Returns the status of the specified outlet. AC outlets are numbers 1-8. Aux Relays
A and B are numbers 9 and 10.
No
set outlet <1 ‐10>
Sets the selected outlet to the selected state. The user must have rights to
the selected
No
get devicename Returns the device name. No Axess ELITE
set devicename Sets the device name. Yes
get reboot Returns the Reboot Time. No
set reboot <1-99> Sets the Reboot Time in seconds. No 5
get delay Returns the Delay Time. No
set delay <0-99> Sets the Delay Time in seconds. No 1
get console Returns the current console timeout and baud rate. No
set autologout <0-99> Sets the automatic logout timeout of web and CLI in minutes. 0 = no timeout. Yes 2
set baud < 2400 | 9600 | 57600 | 115200 > Sets the serial port baud rate. Yes 9600
clear shutdown Clears a persistent shutdown state. No
set clear shutdown by user < yes | no > Sets the ability of a user account to clear a persistent shutdown state. Yes Y
get upload enable Returns the status of the ability to accept a firmware upload. No
set upload enable < yes | no > Sets the ability to accept a firmware upload. Yes Y
clear log Clears history text log file. Yes
set factory defaults Resets all parameters, except Network Settings, to their factory default settings.
Confirmation is required. Note: This command may take up to 30 seconds to execute.
Yes
logout Ends the session. No
reboot Reboots the unit. Will not affect the status of the outlets. No