SurgeX SX-AX20E - Manual (Page 16)

© 2015 SurgeX/Electronic Systems Protection, Inc. | Technical Support: 800-645-9721 | surgex.com
Axess Elite User Manual
Firmware Version v1.06.227
5.5.3 Network Reporting Setup
The Network Reporting Setup page
allows for the configuration of SNMP,
SDxP, and Syslog reporting.
Saving any change which requires a
reboot to take effect will result in the
addition of a “Reboot Required”
button at the bottom of the page.
Network Reporting Setup
Item Description
Enable SNMP Specifies whether or not to enable the SNMP v2c agent.
Read Community Specifies the read community string.
Write Community Specifies the write community string.
SNMP Managers Specifies IP addresses for up to 4 SNMP managers.
Traps Sent Specifies which specific traps are to be sent.
SDxP Port Specifies the port to be used with the SDxP exchange protocol.
The SDxP protocol is the means of communication between master and expansion units
(all of which must use the same SDxP port), and is also the API to be used with the Axess
Elite.
SDxP Manager Specifies the IP address of the SDxP manager.
SDxP Status Broadcast Specifies whether or not to enable a status broadcast and the frequency of the broadcast
messages in minutes.
SDxP Event Reporting Specifies which items are accessible by the SDxP protocol.
SDxP Encryption
Specifies whether or not to use AES encryption with a shared passphrase.
Syslog Port Specifies the port to be used with a Syslog server.
Syslog Server Specifies the IP address of a Syslog server.
15