SurgeX CM-1115-RT-AR - Manual (Page 11)

CM-1115(20)-RT-AR User Manual
Page 10
V. Initial Set-Up
(continued)
Example: Telnet to default IP address of 192.168.1.254 on default Port 23:
SurgeX Axess Ready v1.01.41
User> admin
Password> *****
Axess Ready> set ipaddress 10.1.2.69
Ok
Axess Ready Reboot Required> set subnet 255.255.255.0
Ok
Axess Ready Reboot Required> set gateway 10.1.2.1
Ok
Axess Ready Reboot Required> reboot
The CLI command set ipmode dhcp followed by a reboot command may be
used to configure the AR to automatically acquire its network settings from a
DHCP server. A DHCP server will automatically assign an IP address (dynamic
address), as well as the Subnet Mask and Gateway.
To determine what IP address has been automatically assigned by the DHCP
server, you will need to use the Discover feature of the DMU or query your DHCP
server and locate the MAC address of the AR in the DHCP server’s IP/MAC
table.
Web: To set the IP address using a web browser, navigate to the current IP address of the AR
(192.168.1.254 if the unit is in a factory default state). Enter the administrator credentials (Factory
Default User: admin, Password: admin), click on “Setup”, then click on “Network” and follow the
directions in the Web Server/Network/Setup section of this manual.