Spectrum Controls 1734sc-OE2CIH - Manual (Page 18)

2-4 Chapter 2: Installation and Wiring
User’s Manual Pub. 0300272-01 Rev. A.0
analog module. Position the module:

Away from sources of electrical noise such as hard-contact switches, relays, and
AC motor drives

Away from modules which generate significant radiated heat. Refer to the
module’s heat dissipation specification.
In addition, route shielded, twisted-pair analog input wiring away from any high-voltage
I/O wiring.
Section 2.4
Mounting
2.4.1 Before You Begin
Note that this product can be used with the following:

1734 ControlNet and EtherNet/IP adapters ONLY using RSLogix 5000 software
version 11 or later
Refer to the following figures to familiarize yourself with major parts of the module,
noting that the wiring base assembly is one of the following:

1734-TB or 1734-TBS POINT I/O two-piece terminal base, which includes the
1734-RTB removable terminal block and 1734-MB mounting base

1734-TOP or 1734-TOPS POINT I/O one-piece terminal base