Rocktron Prophesy II - Manual (Page 80)

80
Setting up MIDI Program Changes
MIDI program changes allow for different MIDI program numbers to be assigned to Prophesy
preset numbers. For example, MIDI program #58 can be mapped to Prophesy preset #33. Then,
when program #58 is selected from a MIDI transmitting device (such as a Rocktron All Access foot
controller), preset #33 will be recalled on the Prophesy.
The preset/program change mapping is shipped from Rocktron at a one-to-one correspondence
(i.e., MIDI program #1 is mapped to Prophesy preset #1, 2 to 2, etc.).
The Prophesy can be set to execute program changes as sent from a controller (ON), map
incoming program changes to different Prophesy presets (MAP), or ignore all incoming program
changes (OFF)
Note that the default setting for the Prophesy MIDI transmit channel is OFF in all presets,
therefore no MIDI commands are sent from the Prophesy when a preset is recalled unless it is
configured by the user.
———————————————————————————————————————————————————
1 Use the PAGE control to access the second MIDI page, shown below.
———————————————————————————————————————————————————
2 Use the control labeled “GAIN” to turn the MIDI mapping status to
MAP .
The PRG CHG parameter can be set to any of the following options to
control incoming MIDI program change commands:
OFF : Does not execute incoming MIDI program changes
ON : Executes program changes exactly as received
MAP : Map incoming program change commands to specified
Prophesy presets
PRG CHG
OFF
RECV
1
RECALL
1
RECV
1
RECALL
1
PRG CHG
MAP