Rocktron Prophesy II - Manual (Page 60)

6 0
TAP BUTTON Page
The Tap Button function allows for delay times and tremolo rates to be set by
tapping the front panel TAP button, by a momentary footswitch connected to the rear
panel, or by a control button on a MIDI foot controller like the Rocktron All Access.
Obviously, this is very handy for quickly getting the proper Delay times and/or Tremolo
rates for different song tempos.
The Tap Button page determines which effects that the Tap function will operate on.
The Tap function can work with the Delay time, the Tremolo rate, or both simulta-
neously. These settings will work the same for the front panel Tap button, a momentary
footswitch connected to the footswitch jack, or control messages sent by a MIDI foot
controller.
It is also important to note that: The TAPBTN (Tap Button) parameter settings of
DELAY, TREM or BOTH will only operate as set when viewing any other page except the
delay or tremolo pages. So, for example, if the TAPBTN parameter is set to BOTH and
you're presently viewing the preset title page, and you were to begin tapping the TAP
button, the Delay time and Tremolo speed will be adjusted simultaneously. However, if
you then turn to the Delay page and begin tapping the TAP button, it will effect the
Delay time only. Likewise, viewing the Tremolo page and tapping the TAP button will
effect the Tremolo rate only.