Lingenfelter EFI Live Error Codes - Manual (Page 31)

31
Reading/Flashing Error Codes ($0600..$06FF)
Error Description Cause Action
$0674 Illegal address. An attempt was made to read or reprogram a
memory address in the controller that may
not be read or reprogrammed. Contact EFILive if this error persists.
$0677 Boot loader checksum failed. The boot loader program code has been
corrupted. Re-install the EFILive V8 software.
Contact EFILive if this error persists.
$0683 Battery voltage out of range. The power supply to the controller is either
too high or too low. Please make sure the vehicle’s battery is
fully charged.
If using a bench harness please make sure
the power supply is capable of delivering
12V regulated at 1A.
$0684 Flash chip programming voltage error. The flash chip programming voltage is
incorrect. This error is usually caused by a faulty
controller.
Contact EFILive if this error persists.
$0685 Flash chip could not be programmed. The flash chip and or related circuits in the
controller are faulty. This error is usually caused by a faulty
controller.
Contact EFILive if this error persists.
$0687 Programming voltage did not turn on. The flash chip and or related circuits in the
controller are faulty. This error is usually caused by a faulty
controller.
Contact EFILive if this error persists.
$0688 Programming voltage did not turn off. The flash chip and or related circuits in the
controller are faulty. This error is usually caused by a faulty
controller.
Contact EFILive if this error persists.