Lingenfelter EFI Live Error Codes User Manual
Page 29
29
$0539
Tune file does not allow full flashing.
The author of the tune file has not flagged the
file to allow full flashing.
Contact the author of the file you are
attempting to full-flash for a version of the
file that can be full-flashed.
$053A
Controller could not be licensed.
An attempt was made to re-flash or activate a
license for a target controller that is not
supported by the FlashScan/AutoCal device.
For example: You are attempting to re-flash
or license a Cummins controller with a
FlashScan/AutoCal device that does not have
the Cummins tuning package activated.
Contact EFILive to purchase the required
support.
Or if you believe your FlashScan/AutoCal
device has the correct package(s) activated,
contact EFILive support at
[email protected].
$0540
Incompatible operating system.
An attempt was made to program a controller
with a tune file containing an incompatible
operating system.
Check that the tune file being programmed
has a compatible operating system with the
controller being programmed.
If a 97/98 LS1 controller is in dead poll
mode (i.e. a previous flash failed) then the
operating system cannot be accurately
determined. In that case, you must full-flash
the controller using the EFILive Tuning Tool
software.
$0541
Unknown NVRAM structure.
When full-flashing an LS1B or E54 (LBZ)
controller, the NVRAM structure was not in
the format expected.
Please read the contents of the controller
and send the tune file to EFILive Support
(
) for analysis.
$0542
E35 *.ctz file is not merged with OS.
EFILive only reads calibration data from E35
controllers. Opening and saving the *.ctz file
using the EFILive PC software adds the
necessary operating system data to the file. If
an attempt is made to full-flash the file before
the OS data has been added it will fail.
Please open and re-save the *.ctz file using
the EFILive PC software and then retry the
full-flash.
$0548
Flash checksum failed.
The data programmed into the controller has
been corrupted.
Retry the flash procedure.
If this problem persists, contact EFILive