Lingenfelter EFI Live Error Codes - Manual (Page 25)

25
$050B Script file not supported by current firmware
version The script file uses features not available in
the current firmware. Upgrade the firmware in your
FlashScan/AutoCal device and upgrade the
EFILive software. Then reconfigure
FlashScan/AutoCal using the latest
firmware and software.
$050C Operation not supported Internal Contact EFILive if this error persists.
$050D Controller not supported Internal Contact EFILive if this error persists.
$0510 Internal error Internal Contact EFILive if this error persists.
$0511 Unknown op-code Internal Contact EFILive if this error persists.
$0512 Stack underflow Internal Contact EFILive if this error persists.
$0513 Stack underflow Internal Contact EFILive if this error persists.
$0514 Divide by zero Internal Contact EFILive if this error persists.
$0515 Negative response from controller Internal Contact EFILive if this error persists.
$0516 Could not determine flash memory size Internal Contact EFILive if this error persists.
$0517 File memory size and controller memory
size mismatch An attempt was made to flash a 512K file into
a 1MB LS1B controller or a 1MB file into a
512K LS1B controller. Use the correct file size for the target LS1B
controller.
$0520 Cannot open tune file A tune file that cannot be located to be
verified. This usually indicates that the file
does not exist on the target file system (SD
Card or internal memory). Re-upload or re-copy the tune file.
Check that the target file system is correctly
formatted.