Lingenfelter EFI Live Error Codes - Manual (Page 28)

28
$0534 Invalid Serial Number. An attempt was made to program and license
a controller that had a corrupt serial number. It is possible for the serial number to appear
corrupt due to a data transfer failure. Retry
the operation a few times, if the error
continues to occur then the serial number
probably is corrupt. In that case, use the
EFILive Tuning Tool software to full-flash
the controller to restore the serial number.
$0535 AutoCal is not yet linked to a FlashScan.
See also error $010D An attempt was made to program a controller
using an AutoCal device that has not yet
been linked to its parent FlashScan device. All AutoCal devices must be linked to a
parent FlashScan device before they can be
used to re-flash any controller. Please
connect both FlashScan and AutoCal
devices and then use the EFILive Control
Panel (aka EFILive HAPI) software to
perform the link.
$0536 Tune file is not registered to this AutoCal
device. An attempt was made to program a controller
with a tune file that is not linked to this
AutoCal device. AutoCal devices may only be used to flash
tune files that have been specifically created
for that AutoCal device. To create a tune file
specifically for an AutoCal device, the
FlashScan device to which the AutoCal has
been registered must be connected to the
PC when the tune file is created.
$0537 Controller is locked with a custom key. An attempt was made to read or program a
controller that cannot be unlocked using the
standard GM keys. If you know the key that was used to lock
the controller, please use the unlock option
in the EFILive software to unlock the
controller before attempting to read or re-
flash the controller again.
$0538 DSP Operating Systems cannot be read. Controller contains a DSP Operating System
which can't be read. Once a controller has been upgraded with a
DSP2 or DSP5 custom operating system, it
cannot be read from the controller.