Lingenfelter EFI Live Error Codes - Manual (Page 12)

12
$010A Received data message contained unknown
command action The firmware on the device is out of date Use the EFILive Control Panel software to
update the firmware to the latest version
available.
$010B Device is locked by user PIN FlashScan has been locked with a user
supplied PIN. That PIN has not been entered
correctly since FlashScan was powered up. Enter the correct PIN
If you have forgotten the PIN, send the code
displayed on FlashScan’s LCD screen to
EFILive for recovery.
$010C Device is busy (i.e. BBL or
Reading/Flashing a tune) FlashScan or AutoCal is currently being used
in pass-through mode. Exit from pass-through mode and retry
operation.
$010D AutoCal is not yet linked to a FlashScan.
See also error $0535 An attempt was made to copy data files
too/from an AutoCal device that has not yet
been linked to its parent FlashScan device. All AutoCal devices must be linked to a
parent FlashScan device before files can be
copied. Please connect both FlashScan and
AutoCal devices and then use the EFILive
Control Panel (aka EFILive HAPI) software
to perform the link.