Troubleshooting, Replacing crico tape / neck skin – Laerdal SimMan Essential User Manual
Page 73
MAINTENANCE
73
9 Click
10 Complete the update wizard.
Note that some components might fail updating on first
attempt. Please ignore this and allow the update process
to continue.
The
and show which ones were performed successfully or failed.
• Repeat from step 5 until all components are successfully updated.
• Allow manikin time to save changes and reboot. Do not power off
manikin until it starts breathing again.
Troubleshooting
1 Should the following message appear on the screen during the update, click
to continue the installing updates.
2 If a module fails to update, run the
Should the same module fail repeatedly, check to see whether
all internal wiring is connected and functioning properly.
advanced video Server (avS):
If you use an AVS with your SimMan Essential system, please make sure that all components are updated with the latest software.
Replacing Crico Tape / Neck Skin
After creating an emergency airway through the crycothyroid membrane, replace the perforated membrane before starting a new
simulation session.
1 Remove the neck skin (velcro fasteners behind the neck).
2 Remove the old strip of Crico tape.
3 Replace with a new Crico tape.
4 Refit the neck skin. Secure with velcro fasteners at the back of the neck.
5 Seal the opening with tape.
6 Ensure Crico-tape completely covers and seals the
opening to prevent leakage while ventilating the manikin.
SimMan Ess DFU_RevF.indd 73
18.07.12 14:19