HITEC MD10 - Manual (Page 9)

16 17
Preparations Before Use
Charging
Use the supplied power adapter or USB port of a PC to charge
MD10:
When the MD10 is charged in a power-off state, the red
indicator will flash slowly. After the battery is fully charged, the
red indicator will stay on.
Insert and Remove the Memory Card
MD10 supports an external TF card up to 64G. Though all
SD cards above Class 6 can be used on the MD10, a high-
speed card is recommended for high-definition shooting.
When shooting during dynamic motion, brand SDHC cards are
recommended for use to ensure smooth shooting.
• To insert the memory card, first ensure that the MD10 is
switched off. Next, insert your SD card into the memory
card slot in the direction of the arrow, keeping the card flat
and pushing it to the end. A click will sound when the card
has been inserted completely.
• To remove the memory card, press the center of the
exposed part of your SD card and it will pop up slightly.
Slide the card out.
Before connecting the host to Wi-Fi or the remote control,
please first insert the SD card.
Startup
Slide the Power key to "PWR".
• The power indicator will be lit.
• MD10 will enter the recording standby state and display the
following interface:
00:00:01
2H30
1080P- 25
1
6 5
2
3
4
7
100-0088
1888
8M
1
2
3
4
Press and hold Shutter and Wi-Fi keys to power On/Off.
(Camera in power-on state.)