Hall Research HSM-I-08-08 - Manual (Page 20)

HSM-I-08-08
18
Notice about Additional Commands
HSM matrices equipped with IP Port have special Serial
Commands to change IP address parameters. Please refer section
5.3 IP Specific Serial Commands for further info.
This command is useful for several purposes. For example, if you do not have HDCP
compliant displays on all outputs and you try to send an input with HDCP to an output
display that is not HDCP compliant, you will not get an image. This command enables
you to check the status of each input and only route content that can be displayed to
those outputs. In addition, since this command detects presence of video on inputs,
you can use it to check status of inputs and reroute outputs if there is no video on the
input currently routed.
4.14 Current Status
Command:
ST stands for Status Query
Response:
PW1
CV1,m DH1,x MCx
CV2,m DH2,x OSx
CV3,m DH3,x OTx
CV4,m DH4,x OBx
CV5,m DH5,x NI1,[yyy]
CV6,m DH6,x NI2,[yyy]
CV7,m DH7,x NI3,[yyy]
CV8,m DH8,x NI4,[yyy]
CA1,m AH1,x NI5,[yyy]
CA2,m AH2,x NI6,[yyy]
CA3,m AH3,x NI7,[yyy]
CA4,m AH4,x NI8,[yyy]
CA5,m AH5,x
CA6,m AH6,x
CA7,m AH7,x
CA8,m AH8,x
4.15 Error Commands
ERR1 – Invalid command sent by the user (Any commands other than the above list)
ERR2 – The user sends a command to the HSM matrix while the power is off
ERR3 – The front panel is in use. The front panel times out after 8 seconds if no
activity is detected from the user.