Hall Research HSM-I-08-08 - Manual (Page 13)

Genesis Digital™ HDMI Matrix Switches
11
NOTE
HDMI video output blank/un-blank and embedded audio output active/un-active
can ONLY be performed through RS-232 commands or web browser interface.
When the HDMI video of a selected output is blanked, the embedded audio
associated with that output will be muted.
3.3.2 Making a tie starting from the input
The procedure is similar to the above but a particular input can be routed to more than
one output or none at all!
 Press one of the input channel buttons. That button will light up along with
ALL the outputs routed from that input.
 If you want to change to another input channel, use either the up and down
(▲▼) buttons to walk through other inputs; or just select another input
channel. The up and down (▲▼) buttons can also be pressed and held to
quickly view all input channels one by one.
 To route the selected input to multiple outputs, press the desired output
buttons. Again, these new outputs are only “candidates” (will be blinking)
and will not be routed until you hit SET.
 Any outputs tied to this selected input can’t be disconnected from it.
3.4 Saving Presets (routing patterns)
The number of presets accessible from the front panel is the same as the total # of
input buttons. Each front panel input button can memorize a pattern. Therefore, you
can recall 8 presets.
Current tie configurations can be saved as presets (1 through 8) for later recall.
To save the current AV routing pattern, press and hold the PRE button for 3 sec, the
backlit LED will start flashing (this means that save function is activated). Press the
desired input button to save the preset then press the SET button to complete the
operation.
3.5 Recalling Presets (routing patterns)
Press and release the PRE (preset) button. The button will light up solid. Then press
and release one of the input channel buttons and hit SET.