Maintenance, 3 status – Glow-worm Clearly Hybrid - Back-up Module System User Manual
Page 36

0020096317_01 - 08/10 - Glow-worm
- 34 -
MAINTENANCE
fault
codes Description
Cause
Solution
030
Failure in communication with the zone 1 wireless
room thermostat.
The room thermostat is too far from the
control unit.
There is a problem with the batteries in
room thermostat.
Check the RF signal quality via the
Climapro2 RF installer menu.
Check the location of the thermostat.
Check that the thermostat’s batteries are
installed in their compartment.
Make sure the battery polarity is not
reversed.
Make sure the batteries are not dead.
If so, replace them with new batteries
031
Failure in communication with the zone 2 wireless
room thermostat.
032
Failure in communication with the zone 3 wireless
room thermostat.
033
Failure in communication with the zone 4 wireless
room thermostat.
034
Failure in communication with the zone 5 wireless
room thermostat.
035
Failure in communication with the zone 6 wireless
room thermostat.
036
Failure in communication with the wireless
outdoor sensor
The wireless outdoor sensor is too far
from the control unit.
Check the location of the outdoor sensor.
Check that the sensor’s power supply is
correctly provided by a photovoltaic cell.
15.2.2
boiler fault codes
• Consult the boiler installation manual for information about
the fault codes.
15.2.3
Heat pump fault codes
• Consult the heat pump installation manual for information
about the fault codes.
15.3 Status
15.3.1
boiler status
• Consult the boiler installation manual for information about
the status codes.
15.3.2
Heat pump status
• Consult the heat pump installation manual for information
about the status codes.