EZ-ACCESS TITA MODULAR ACCESS SYSTEM - Manual (Page 4)

– 4 –
BEFORE YOU BEGIN:
1. Read and follow all instructions/warnings prior to assembly and use.
2. Load rating: 100 lbs. psf live load, 300 lbs. concentrated
TOOLS NEEDED:

Tape measure

Level

9/16” socket or wrench

1/2” socket or wrench

3/16” hex key wrench

5/32” hex key wrench

5/16” masonry drill bit (if installing ramp to concrete porch, steps, etc.)

Hammer

#3 square drive bit

File

Power drill

Metal cutting chop saw or reciprocating saw

Digging tools (if an obstacle needs to be removed)

Two able-bodied persons needed for installation

Pop rivet gun (needed for child rail and corner cover plate installation only)
1. ASSEMBLE/SET PLATFORMS:
1.1 Determine platform height requirement.
1.1.1 Insert support legs into corner pockets at corners of platform (FIG. 1). Position foot pads so
that they do not protrude past perimeter of the platform. Note: The support legs are also
used to support the guardrails and when installed, the support tubes must protrude at least
24” above the platform walking surface (FIG. 2).
1.1.2 Ensure that the correct length support tubes are used.
1.1.3 Adjust legs to approximate height required then secure leg adjustment by tightening
setscrews with 3/16” hex key wrench.
1.2 Position platform in desired location then make final height and level adjustments.
1.3 Ensure support legs are secure by tightening setscrews (a total of eight, two in each corner).
1.4 Assemble all platforms required in this fashion. Guardrails and handrails will be installed after
platforms and ramps are assembled and set.
FIG. 1 FIG. 2