EZ-ACCESS TITA MODULAR ACCESS SYSTEM - Manual (Page 19)

– 19 –
8.4 At a turn platform on the outside, non-turn side (both where a the top of a ramp meets a platform
and where a ramp starts at a platform) as shown in FIG. 35:
8.4.1 Use a ring joiner to attach one 5 degree elbow to ramp handrail.
8.4.2 Hold 90 degree elbow in position and mark for trimming.
8.4.3 After trimming, test fit elbow.
8.4.4 When fit is confirmed, install threaded insert into short end of elbow with a hammer.
8.4.5 Connect long side to 5 degree elbow with a ring joiner.
8.4.6 Connect short end to vertical tube on guard with 5/16”-18 x 2” button head screw.
8.4.7 Tighten all fasteners securely.
FIG. 35
8.5 At a turn platform at top of system on inside turn side (FIG. 36):
8.5.1 Hold 90 degree elbow and handrail bracket in position and mark for trimming.
8.5.2 After trimming, test fit elbow along with handrail bracket and spacer.
8.5.3 When fit is confirmed, install end cap on open end of long leg of elbow.
8.5.4 Attach short leg of elbow to handrail tubes with a ring joiner.
8.5.5 Attach handrail bracket and spacer to guard filler section by drilling 5/16” dia. hole through
guard filler picket, and then secure using one 5/16”-18 x 3” bolt, nut and washer.
8.5.6 Attach elbow to handrail bracket using one 1/4” x 1” long self drilling square drive screw.
8.5.7 Tighten all fasteners securely.
FIG. 36