EXFO IQS-12002B Calibration System - Manual (Page 37)

Operating Your Calibration System
Calibration System 33
Performing a Test
12. From the Measurement and Adjustment Procedure Selection box,
select the scenarios you want to include in your test sequence.
Note: Some scenarios cannot be cleared from the list. These are mandatory
scenarios and must be performed for the selected DUT.
13. To create custom specifications for a scenario, proceed as follows:
13a.Select the scenario you want to customize and click Create.
13b.From the Based on list, select a set of specifications to be used as
a template.
13c. Click Customize to create the new set of specifications and
values.
13d.Click OK.