beautypg.com

2 getting started with your calibration system, Inserting and removing test modules, 2getting started with your calibration system – EXFO IQS-12002B Calibration System User Manual

Page 15: 2b 2a, Aution

background image

Calibration System

11

2

Getting Started with Your

Calibration System

Inserting and Removing Test Modules

To insert a module into the controller or expansion unit:
1.
Exit IQS Manager and turn off all your units.

2. Remove the protective cover from the desired unused module slot.

2a. Pull the retaining screw knob firmly towards you and release the

bottom of the cover.

2b. Gently pull the top of the protective cover downwards, to remove

it from the unit grooves.

3. Position the module so that its front panel is facing you and the top and

bottom protruding edges are to your right.

C

AUTION

Never insert or remove a module while the controller unit and its
expansion units are turned on. This will result in immediate and
irreparable damage to both the module and unit.

Retaining screw

knob

Protective cover

2b

2a