EXFO FTB-5230S Optical Spectrum Analyzer for FTB 200 v2 - Manual (Page 23)

OSA/OCA 17
4 Preparing Your OSA/OCA for a
Test
Cleaning and Connecting Optical Fibers
To connect the fiber-optic cable to the port:
1. Inspect the fiber using a fiber inspection microscope. If the fiber is
clean, proceed to connecting it to the port. If the fiber is dirty, clean it as
explained below.
2. Clean the fiber ends as follows:
2a. Gently wipe the fiber end with a lint-free swab dipped in isopropyl
alcohol.
2b. Use compressed air to dry completely.
2c. Visually inspect the fiber end to ensure its cleanliness.
I
MPORTANT
For optimal test results, you should allow a minimum warm up
period of two hours for your OSA/OCA before starting your tests.
I
MPORTANT
To ensure maximum power and to avoid erroneous readings:

Always inspect fiber ends and make sure that they are clean as
explained below before inserting them into the port. EXFO is
not responsible for damage or errors caused by bad fiber
cleaning or handling.

Ensure that your patchcord has appropriate connectors. Joining
mismatched connectors will damage the ferrules.