EXFO FTB-3930 MultiTest - Manual (Page 20)

Setting Up Your Multifunction Loss Tester
14 FTB-3930
Setting Autonaming Scheme
Setting Autonaming Scheme
When starting a new file, the unit suggests an initial fiber name. After
adding a result to the Tested fibers list, the unit prepares the next fiber
name by incrementing the suffix.
When you manually change the name for the first time (in Power Meter,
ORL Meter or
F AS T ES T), the unit then ignores autonaming settings.

Cable names: maximum 60 characters for prefix, plus 3-digit suffix
(or Microsoft Windows limitations when name is manually set)

Fiber names: maximum 11 characters for prefix, plus 3-digit suffix
(duplicate names allowed when name is manually set)
Note: If you manually change a fiber name, then turn the unit off without saving
at least one result, this name will be discarded.
I
MPORTANT
To start using new autonaming settings, you must close the current
file.