The power-on self test (post), The power-on self test (post) -2, Bios utilities 5 - 2 the power-on self test (post) – Eurocom M660N MILANO User Manual

Page 82: Figure 5 - 1

BIOS Utilities

5 - 2 The Power-On Self Test (POST)

The Power-On Self Test (POST)

Each time you turn on the computer, the system takes a few seconds to conduct a
POST, including a quick test of the on-board RAM (memory).

As the POST proceeds, the computer will tell you if there is anything wrong. If there
is a problem that prevents the system from booting, it will display a system summary
and prompt you to run Setup.

If there are no problems, the Setup prompt will disappear and the system will load
the operating system. Once that starts, you can’t get into Setup without rebooting.

POST Screen

1.BIOS information
2.CPU type
3.Memory status
4.Enter Setup prompt

appears only during
POST

Note: The POST screen
as pictured right is for
guideline purposes only.
The POST screen on
your computer may ap-
pear slightly different. If
you disable the Boot-
time Diagnostic Screen,
the POST screen will not
appear.

Figure 5 - 1

POST Screen

Phoenix TrustedCore(tm) NB

Bios Revision: ******

KBC/EC Ver: ******

CPU = 1 Processors Detected, Cores per Processor - 2

Intel(R) Core(TM)2 CPU

T2700 @ 2.00GHz

1015M System RAM Passed

4096 KB L2 Cache

System BIOS shadowed

Video BIOS shadowed

Fixed Disk 0: TOSHIBA MK6034GSX

ATAPI CD-ROM: TSSTcorpCD/DVDW TS-L632D

Mouse intialized

Press to enter SETUP