Eurocom M560A DIVINE - Manual (Page 84)

BIOS Utilities
5 - 4 The Setup Program
5
The Setup Program
The Phoenix Setup program tells the system how to configure itself and man-
age basic features and subsystems (e.g. port configuration).
Entering Setup
To enter Setup, turn on the computer and press F2 during the POST. The
prompt (Press F2 to Enter Setup) seen in
Figure 5 - 1 is usually present for a
few seconds after you turn on the system. If you get a “Keyboard Error”, (usu-
ally because you pressed F2 too quickly) just press F2 again.
If the computer is already on, reboot using the Ctrl + Alt + Delete combina-
tion and then hold down F2 when prompted. The Setup main menu will ap-
pear.