Eurocom Neptune 3 - Manual (Page 191)

Modules
Setting Up SATA RAID or AHCI Mode 7 - 5
7
1. Go to the operable computer and insert a USB Flash drive or external USB hard
disk.
2. Insert the Device Drivers & Utilities + User’s Manual disc into the CD/DVD drive
of the operable computer.
3. Copy the f6flpy-x86 or f6flpy-x64 folder from the location below (D: denotes your
DVD drive) on the Device Drivers & Utilities + User’s Manual disc to the USB
flash drive or external USB hard disk.
• For Windows 8 32bit = D:\Options\RAID\f6flpy-x86
• For Windows 8 64bit = D:\Options\RAID\f6flpy-x64
4. Start-up your notebook computer and press to enter the BIOS.
5. Go to the Boot menu, select UEFI Setting and press (see page 5 - 14 ).
6. Set UEFI Boot to “Enabled”.
7. Press to exit the menu and go to the Advanced menu.
8. Select SATA Mode (see page 5 - 10 ), press and select “RAID Mode”.
9. Press and to “Save Changes and Reset”.
10. After computer restarts press to enter the BIOS again.
11. Go to Intel(R) Rapid Storage Technology (in the Advanced menu) and press
.
12. Select Create RAID Volume and press .
Figure 7 - 1
Create RAID Volume
(Advanced > Intel(R)
Rapid Storage
Technology