Operating system setup, Operating system setup -7, Is selected as the o/s – Eurocom M720R GALAXY-X User Manual
Page 29: Operating system setup 1 - 7 quick start guide, Only available if windows vista, Advanced bios menu
Operating System Setup 1 - 7
Quick Start Guide
1
Operating System Setup
If you are installing new system software, or are re-configuring your computer for a different system, make sure you
configure the appropriate OS setting in the BIOS before installing a new operating system (see
1. Start-up the computer and press <F2> to enter the BIOS.
2. Go to the Advanced menu, select "Installed O/S" and make sure the appropriate operating system is selected.
3. Go to the Exit menu and select "Exit Saving Changes" (or press F10 and select "Yes" then press Enter) and
press Enter to exit the BIOS and reboot the computer.
Figure 1 - 2
- Advanced BIOS Menu
Main
Advanced
Security
Boot
Exit
F1
Help
Select Item
-/+
Change Values
F9
Setup Defaults
Esc
Exit
Select Menu
Enter
Select
Sub-Menu
F10
Save and Exit
Item Specific Help
Advanced
Select options for
Advanced Chipset
features.
Phoenix SecureCore(tm) Setup Utility
Advanced Chipset Control
Installed O/S:
[Vista]
SATA Mode Selection:
[AHCI]
DFOROM(Robson) Support:
[Disabled]
Reset Configuration Data:
[No]
Boot-time Diagnostic Screen:
[Disabled]
Legacy OS Boot:
[Enabled]
Power On Boot Beep
[Disabled]
Battery Low Alarm Beep:
[Disabled]
FAN Control:
[Automatic]
Only available if Windows Vista
is selected as the O/S.
SATA Mode Selection & Intel Turbo
Memory
If you select the Vista O/S then the SATA
Mode Selection menu will become available.
If you have included an Intel Turbo Memory
module in your purchase configuration you will
need to enable DFOROM (Robson) Support
and then install the driver (see
).