ENMET MEDAIR 2200 - Manual (Page 8)

M ED A IR 2200 ENMET Corporation
5
3.0 Installation
3.1 Mounting of Instrument
The M ED A IR 2200 should be located near the pipe or tank containing the air to be monitored, and upstream from
where the air is being used. The M ED A IR 2200 must be installed such that it samples the compressed air before it
reaches the users.
Mount the instrument on an appropriate vertical surface using the mounting flanges provided. Avoid areas with
excessive vibration or temperature extremes. The holes in the flanges are 0.31 inch in diameter and form a 6 x 10.75
inch rectangle. See Figure 3.
It is recommended to use #8 drywall anchors and screws for mounting the M ED A IR 2200 to a drywall/sheetrock
surface.
Dimensions are in inches.
Figure 3: M ED A IR 2200 Mounting Dimensions
Mounting Holes
0.31” dia. 4 places