ENMET MEDAIR 2200 User Manual
Page 26
M
ED
A
IR
2200
ENMET Corporation
23
5.3.8 Set New Password
To change the password, you must enter the maintenance menu. Press the
OPTION
switch until “Enter Maint Menu” is
displayed then press
SELECT
switch for the Enter Password menu. Enter the valid password as described in Section 5.2.1.
To set a new password, after inserting a valid password,
Press the
OPTION
switch until; "
Set New Password”
is displayed.
Press the
SELECT
switch; "
Password
❚
1270
" is displayed, with the underscore cursor under the left digit.
Use the
OPTION
switch to change the left digit, when the desired digit is displayed.
Press the
SELECT
switch to lock the digit in place and move the cursor one digit to the right.
When all four digits of the new password have been selected, "
Set New Password
" is displayed.
Record the new password; without it, the maintenance menu cannot be reentered once you exit the Maintenance Menu.
If the password is lost, call
ENMET
customer service personnel.
From the "
Password XXXX
" position,
Press the
SELECT
switch to return to Set New Password section.
Press the
OPTION
switch; to continue to "
exit MAINTENANCE Menu
"
Example: Set Password Flow Chart
5.3.9 Exit Maintenance Menu
From the "
exit MAINTENANCE Menu
" position
Press the
SELECT
switch to resume the operational display.
Press the
OPTION
switch to reenter the maintenance menu at the "
Calibration
" position.
Example: Exit Maintenance Menu Flow Chart
O
S
MAINTENANCE MENU
Set New Password
Password
❚0000
O
S
Changes digit indicated by underscore cursor
Locks underscored digit and moves cursor to next digit
MAINTENANCE MENU
Calibration
MAINTENANCE MENU
Exit maint menu
CH-1
CH-3
CH-2
CH-4
S
O
O = Press Option
S = Press Select