ENMET MEDAIR 2200 - Manual (Page 6)

M ED A IR 2200 ENMET Corporation
3
Figure 1: External Features of the M ED A IR 2200
* N OTE : Typical gas reading & alarm locations, depending on instrument configuration, alarms &
readings may be in alternate locations
Sample Air Hose, 5ft Supplied with Monitor
Example of Regulator, Not Supplied with Monitor
Figure 1A: Sample Air Hose and Regulator
N OTE : Typical facility air line pressures range from about 55 to 125 PSI . The outlet pressure of the
regulator can be connected to the inlet of the M ED A IR 2200 and should be set at 55 PSI ,
±
5 PSI .
Regulator not supplied with the monitor
O
2
%
CO
ppm
Front Cover Latch
Male Quick Release Fitting
Input Port
Sample/Calibration
See note below
Audio Alarm
Fault LED
SELECT
Switch
Power LED
OPTION
Switch
A LARM A CKNOWLEDGE /
A LARM D EFEAT
Switch
*Visual Alarm O2
(If Oxygen option is installed)
See *note below
*Visual Alarm CO
(See *note below)
Mounting Flanges
2 places
Dew
Point
*Visual Alarm
Dew Point
( If Dew Point option
is installed)
See *note below
Display, see *note below
CO reading O
2
reading
Dew Point reading
Channel #1 Channel #3
Channel #4 Channel #2
Visual Alarm 2
ALARM 2
Female Quick Release
to Inlet Port to M
ED A IR 2200
¼” NPT
N OTE : When connecting to a standard 55 PSI USA Medical air system, Regulator is Not required.
Male¼” NPT Fitting
To Air System
Female Quick Release
to Sample Port