Echelon Rapid Deployment Example for EES - Manual (Page 21)

Rapid Deployment Example for EES 11
4. The Deploy Web page opens.
5. Accept all the default setting. Do not modify the default Target name, which is QSR. If you
modify the Target name, you will not be able to create a LonMaker drawing for the deployed
LNS network database.
6. Enter the following SOAP/HTTP settings for your target SmartServer:
Protocol Select the protocol used by the i.LON AdminServer to connect to the
SmartServer (HTTP or HTTPS). The selected protocol must be enabled
in the Setup - Security Web page in the SmartServer Web interface;
otherwise, the following error occurs when the i.LON AdminServer tries
to access the SmartServer: ERROR: WebService reports: "Could not
connect to i.LON SmartServer!"
• To use HTTP, the Enable Web Server check box in the Setup -
Security Web page must be selected.
• To use HTTPs, the Enable SSL Web Server check box in the Setup
- Security Web page must be selected.
Url Enter the IP address or hostname for the SmartServer to be added to the IP
channel
Port (Web
Server/SOAP) Enter the port the SmartServer uses to serve HTTP or HTTPs requests
(SOAP and WebDAV). If you are using HTTP, the default value is 80.
If you are using HTTPs, the default value is 443. You may change the
port to any valid port number.