Ditch Witch RT115 Q - Manual (Page 92)

RT115Q Operator’s Manual
Plow - 91
Setup
CMW
Position Tractor
1. Fasten and adjust seat belt.
2. Start tractor. See page 64 for start-up procedures.
3. Drive to starting point. Move in line with planned trench.
4. Engage parking brake and verify parking brake indicator is on.
5. Lower backfill blade, if equipped.
6. Set Trench / Plow switch to the plow position.
7. Lower plow to starting point of trench.
8. Turn ignition switch to STOP.
Attach Product
To Pull Product
1. Insert material into pulling grip.
2. Tape grip with duct tape.
IMPORTANT: If material must be at a constant depth, dig starting and target trenches.