Delta RMC70 - Manual (Page 20)

RMC70 Startup Guide
18 Delta Computer Systems, Inc.
AA Module
1. In the Axis Parameters pane,
on the Setup tab, set the
Input Type to Voltage or
Current.
2. Click the Download button
to apply the changes to the
RMC.
3. Continue to the Verify Feedback section on page 19.
A2 or AP2 Module
1. In the Axis Parameters pane, on the Setup tab, set the Input Type
to Voltage or Current.
If the input is the primary input of the axis, the Input Type is
under the Primary Control Setup section in the Axis Parameters.
For secondary pressure or force inputs on a dual-loop axis, the
Input Type is under the Secondary Control Setup section in the
Axis Parameters.
2. Click the Download button to apply the changes to the RMC.
3. Continue to the Verify Feedback section on page 19.
QA or Q1 Module
The QA and Q1 module do not require any configuration.
1. Continue to the Verify Feedback section on page 19.