Delta RMC70 User Manual

Page 16

Text mode
Original mode

RMC70 Startup Guide

Delta Computer Systems, Inc.

6. Browse to Motion Commands,

then Open Loop.
Choose the Direct Output
command and click OK.

7. For the Direct Output command

parameters, enter the following:



Output: 0.1



Ramp Rate: 100

When you send the command in the
next step, the Control Output voltage
will ramp to 0.1 V at a rate of 100
V/sec.

USE THE DIRECT OUTPUT COMMAND WITH CAUTION!
IT DISABLES THE SAFETY FEATURES OF THE RMC!

Fault Controller
Button
If the motion causes problems, be prepared to quickly stop the
axis by clicking the Fault Controller button on the toolbar, or
pressing Ctrl + K on the keyboard.