Digicom COMSPHERE 3910 - Manual (Page 58)

COMSPHERE 3900 Series Modems
4-8 September 1998 3910-A2-GN32-40
To access Backup from the Status branch, make the following selection:
Press the key until Backup appears.
F1
Status:
DTE
Backup
F2 F3
Select Backup.
F1
Status:Backup >
Line=Pri 4w APL
F2 F3
The configuration of the current operating line facility (either APL primary or backup) appears
(Refer to Table 4-2).
Press the key to display the next screen.
F1
Status:Backup <
Bkup:2wAPL=Good
F2 F3
This screen displays the configuration and condition of the inactive line facility (either APL
primary or backup).
There are four condition codes, Good, Bad, ????, and ‘ ’ (blank).
Table 4-2 provides information about the Status Backup screens. The first column lists all
possible configurations for the modem’s currently active line. The second column lists all
possible configurations for the modem’s inactive lines. The third column provides information
about the inactive line condition.
XXXX represents the condition code of the inactive line.