Digicom COMSPHERE 3910 - Manual (Page 149)

10-1 3910-A2-GN32-40 September 1998
Call Setup Branch
Overview
The Call Setup function is not available in TMp Control mode.
For dial backup applications, the Call Setup branch of the Top-Level menu allows you to dial,
disconnect, and answer telephone calls. For leased backup applications, the Call Setup branch
allows you to switch between the primary leased line and the backup leased line.
In leased backup operation, a 2-wire leased line is used as the backup facility instead of the
normal 2-wire dial line. Plug the leased line into the jack labeled DIAL on the rear panel of the
modem and enable the Dual_Leased_Ln configuration option. (Refer to Leased Line in
Chapter 5, DCP Configuration, for configuration options.) Except for dialing, ring indication,
and call progression functions, you control the backup function as if it were a normal dial
backup.
Call_Setup
“Status”
Status Configure PList Control Test SubHS Tlk/Data Security Remote
Dial Disconnect Answer Dial_Standby
or
Return_to_Dial
Change_Directory
(Dial
Backup
only)
Directory Locations 1 - 24
Directory_Status
(Does not appear
in North America)
10