Digicom COMSPHERE 3910 - Manual (Page 125)

Control Branch
7-5 3910-A2-GN32-40 September 1998
After selecting the desired interface, the message Command Complete appears on the bottom
line of the LCD and the selected interface appears in the xxxxx field.
To exit this function and remain in the Control branch, press the key. To exit and return to
the Top-Level menu, press the key.
NOTE
The Port1 interface is the only display allowed on the 3911 modem,
therefore, the entire EIA LEDs branch is masked.
Make Busy/Remove Make Busy
The Make Busy function forces the modem off-hook so it cannot answer a call. This is often
used with PBX systems to permit the busy out of a PBX port for rotary or hunt groups.
WARNING
To prevent violations of FCC and DOC regulations, this
function must only be used behind a user’s PBX.
To access Make Busy from the Control branch, make the following selections:
F1
Control:
Make_Busy
F2 F3
Press the key until Make_Busy appears. Select Make Busy.
F1
Make Busy
Command Complete
F2 F3
The modem is now in a forced busy condition. Command Complete appears on the LCD.