Desa GA3700 - Manual (Page 18)

www.desatech.com 113109-01G 18
INSTALLATION
Continued
Notches
Figure 26 - Installing Fireplace Screen
Screws for
Mounting Screen
OpTIONAL WIRELESS HAND-HELD
REMOTE CONTROL ACCESSORIES
(HRC100 and HRC200)
Installing Remote Receiver Unit
1. Disconnect switch wires from the con-
trol valve.
2. Remove screws attaching switch plate.
3. Remove switch plate (see Figure 27).
Discard after removing.
4. Install remote receiver unit onto gas log
heater base using mounting clips.
5. Push clips firmly into place (see Figure 28).
6. Connect wires as shown in Figure 29.
Figure 27 - Switch Plate and Wiring
Harness
Figure 28 - Installing Remote Receiver
Valve
White Wire
From Receiver
Screw
Switch Plate Wires
Remote
Switch
Bracket Ignitor
Remote Receiver
Mounting
Clips
Figure 29 - Connecting Wires
Red Wire From
Receiver
INSTALLING 9-vOLT BATTERIES
Two 9-volt batteries (not included) are re-
quired to operate this heater with the wireless
hand held remote control set. Install one bat-
tery in the receiver and one in the hand-held
remote control unit.
Note: Only use alkaline batteries.
Installing 9-Volt Battery in Receiver
1. Locate back of receiver under front burner
of heater.
2. Locate the battery clip mounted on the
back of the receiver.
3. Slide a 9-volt battery through the clip.
4. Attach the terminal wires to the battery.
Figure 30 - Installing Battery in Remote
Receiver
Battery Clip
9-Volt Battery
Remote
Receiver Terminal Wires