Desa Wall Mantel with Base and Trim WD26CPA - Manual

www.desatech.com
Important: Read entire instruction sheet before as-
sembling or installing mantel kit.
This mantel is only approved for use with any DESA
Heating Products 26" fireplace system. Do not use mantel
with any other product.
• Mantel pieces - unassembled and marked as follows:
Base #1
Left Front Leg #5 with arrow
Right Side #2 with arrow Header #6 with arrow
Right Front Leg #3 with arrow Top #7
Left Side #4 with arrow
• Hardware package
117197-03
• Trim kit GAB6094
• Trim kit hardware 102866-01
• Bracket hardware kit 118983-01
The hardware package 117197-03 contains the following:
• 2 - 3" screws
• 18 - 1 1 ⁄
4
" screws
The bracket hardware kit 118983-01 contains the following:
• 13 - Brackets
• 2 - Flat brackets
• 36 - Wood screws
Tools and items required:
• #2 Phillips driver bit (3 1 /
2
" minimum length)
• Slotted screw driver
• Measuring tape
• Pencil
• Drill Driver
If any wood pieces are missing or damaged, contact the
dealer where you purchased this mantel for replacement.
If hardware or trim is missing or damaged, contact DESA
Heating Products at 1-866-672-6040 for referral and war-
ranty information. You can also visit DESA Heating Products'
technical service web site at www.desatech.com.
Note: Gather all mantel pieces together before assembling
mantel.
WARNING: Only use 1 1 /
4
" screws in pocket holes
to assemble mantel. Damage to mantel will result if
other screws are used for this purpose.
WARNING: Use only 1/2" or 3/4" screws with brack-
ets in hardware pack 118983-01. Damage to mantel will
result if other screws are used for this purpose.
WS26CP and WD26CPA
Wall Mantel with Base and Trim
ASSEMBLY AND INSTALLATION INSTRUCTIONS
Firebox
Perimeter
Trim Included
With This
Mantel