AMT Datasouth 2012 M6 Plus User Manual

Page 76

The default IP address is obtained by DHCP. To change the setting to static IP address, click

“Static IP” radio button then enter the IP address, subnet mask and gateway. Click “Set IP” to

take effect the settings.

Users can also change the “Printer Name” by another model name in this fields then click “Set

Printer Name” to take effect this change.

Note: After clicking the “Set Printer Name” or “Set IP” button, printer will reset to take

effect the settings.

8. Click “Exit” button to exit the Ethernet interface setup and go back to Diagnostic Tool main

screen.

Factory Default button

This function will reset the IP, subnet mask, gateway parameters obtained by DHCP and reset

the printer name.

Web setup button

Except to use the Diagnostic Utility to setup the printer, you can also explore and configure the

printer settings and status or update the firmware with the IE or Firefox web browser. This

feature provides a user friendly setup interface and the capability to manage the printer

remotely over a network.