AMT Datasouth 2012 M6 Plus User Manual

Page 37

Batch Mode

Once image is printed completely, label gap/black mark will be

fed to the tear edge for tear away.

Peeler Mode

Enable the label peel off mode.

Cutter Mode

Enable the cutter mode.

Cutter Batch

Cut the media once at the end of the printing job.

Note: If printing from enclosed software/driver, the software/driver will send out the

command, which will overwrite the setting set from the front panel.

3.1.1-1.5 Offset:

This option is used to fine tune media stop location for peeler and cutter mode. Press the

button to move the cursor from left digit to right digit, and press the

button to

set the value from “+” to “-” or “0” to “9”. Press the

button to set the value into printer.

Press

key to cancel the setting and return to the previous menu. The default value

is +000.

Note: If printing from enclosed software/driver, the software/driver will send out the

OFFSET command, which will overwrite the setting set from the front panel.

3.1.1-1.6 Shift X & Shift Y:

Print Setup 5/12

Direction

Print Mode

Offset

+000

Print Setup 7/12

Offset

Shift X

Shift Y

+000

This option is used to fine tune print position. Press the

button to move the cursor

from left digit to right digit, and press the

button to set the value from “+” to “-” or “0” to

“9”. Press the

button to set the value into printer. Press

key to cancel

the setting and return to the previous menu. The default value is +000.