ADLINK PCM-9112+ - Manual (Page 53)

C/C++ Library • 45
5.3 _9112_Initial
@ Description
A PCI-9112 card is initialized according to the card number. Because
the PCI-9112 has a PCI bus architecture and meets the plug and play
design, the IRQ and base_address (pass-through address) are assigned
by system BIOS directly. Every PCI-9112 card has to be initialized by
this function before any other function calls are allowed.
Note: Because configuration of PCI-9112 is handled by the system, there is
no jumpers or DMA selection on the PCI boards that need to be set
up by the users.
@ Syntax
Visual C++ (Windows-95)
int W_9112_Initial (int card_number, int *base_address,
int *irq_no)
Visual Basic (Windows-95)
W_9112_Initial (ByVal card_number As Long, base_address
As Long, irq_no As Long) As Integer
C/C++ (DOS)
int _9112_Initial (int card_number, int *base_address,
int *irq_no)
@ Argument
card_number: the card number to be initialized, only four cards can be
initialized, the card number must be CARD_1, CARD_2,
CARD_3, or CARD_4.
base_address: the I/O port base address of the card, it is asigned by system
BIOS.
irq_no: system will give an available interrupt number to this card automatically.
@ Return Code
ERR_NoError, ERR_InvalidBoardNumber
ERR_PCIBiosNotExist, ERR_PCICardNotExist
ERR_PCIIrqNotExist